HP Virtual Connect 8Gb 24-port Fibre Channel Module for c-Class BladeSystem - Manual (Page 37)

Command line 37
Item Description
supported speed values include "Auto","1Gb","2Gb", "4Gb", and
"Disabled". If the value is set to 8Gb, the speed is auto-negotiated by Virtual
Connect.
AddressType (optional) The source of WWN address assignments to be used during the creation of the
new connection. If not specified, the default is the domain default. If
"User-Defined" is specified, then both a Port WWN and Node WWN must also
be specified. Valid values include "Factory-Default" and "User-Defined".
PortWWN (required if
AddressType is
User-Defined)
The user-defined Port WWN address to use for the connection. This property is
required if the AddressType specified is "User-Defined". The PortWWN must be
an unused WWN address.
NodeWWN (required if
AddressType is
User-Defined)
The user-defined Node WWN address to use for the connection. This property
is required if the AddressType specified is "User-Defined". The NodeWWN
must be an unused WWN address.
Examples
->add fc-connection MyNewProfile Fabric=SAN_5
Adds a new FC SAN connection to a profile
->add fc-connection MyNewProfile Fabric=SomeFabric
Speed=4Gb
Adds a new FC SAN connection and configures the port speed
->add fc-connection MyNewProfile
Adds a new FC SAN connection and uses the next available fabric
->add fc-connection MyNewProfile
AddressType=Factory-Default
Adds a new FC SAN connection and uses factory-default addresses
->add fc-connection MyNewProfile AddressType=User-Defined
PortWWN=50:06:0B:00:00:C2:62:00
NodeWWN=50:06:0B:00:00:c2:62:01
Adds a new FC SAN connection and provides user-defined WWN addresses
Item Description
remove fc-connection Remove the last FC connection from an existing server profile.
Syntax
remove fc-connection <ProfileName>
Parameter
ProfileName (required) The name of an existing profile from which the last FC connection is being
removed
Example
->remove fc-connection MyProfile
Removes an FC connection from a profile
Item Description
set fc-connection Modify an existing FC SAN connection.
Syntax
set fc-connection <ProfileName> <Port>
[Fabric=<FabricName>]
[Speed=<Auto|1Gb|2Gb|4Gb|8Gb|Disabled>]
[BootPriority=<priority>] [BootPort=<portName>]
[BootLun=<LUN>]
Parameters
ProfileName (required) The name of the server profile that contains the connection being modified
Port (required)
The port number of the connection being modified