HP Virtual Connect 8Gb 24-port Fibre Channel Module for c-Class BladeSystem - Manual (Page 38)

Command line 38
Item Description
Properties
Fabric (optional) The name of the FC SAN fabric to associate with the connection. The fabric
being specified should be associated with the same bay as the FC connection.
A blank string makes the FC connection unassigned.
Speed (optional) The port speed of the FC SAN connection. Valid values include "Auto", "8Gb",
"4Gb", "2Gb", "1Gb", and "Disabled".
Speed restrictions:
For the HP 4Gb VC-FC Module and HP Virtual Connect 4Gb FC Module,
supported speed values include "Auto","1Gb","2Gb", "4Gb", and
"Disabled". If the value is set to 8Gb, the speed is auto-negotiated by Virtual
Connect.
BootPriority
(optional)
Controls whether the FC HBA port is enabled for SAN boot and affects the BIOS
boot order. Valid values include "BIOS", "Primary", "Secondary", and
"Disabled".
BootPort
(Required if the Boot Priority is
either Primary or
Secondary optional)
The target WWPN of the controller interface on the Fibre Channel storage
target. The port name is a 64-bit identifier in the format
NN:NN:NN:NN:NN:NN:NN:NN, where N is a hexadecimal number.
BootLun
(Required if the Boot Priority is
either Primary or
Secondary optional)
The LUN of the volume used for SAN boot. Valid values include an integer from
0 to 255 or 16 hex digits (HP-UX only).
Examples
->set fc-connection MyProfile 1 Fabric=SAN_5
Changes the fabric of an FC SAN fabric connection
->set fc-connection RedProfile 2 Fabric=""
Sets an FC SAN fabric connection to "Unassigned"
->set fc-connection BlueProfile 1 Fabric=SAN_7
Changes the FC SAN fabric of an FC SAN connection
->set fc-connection BlueProfile 1 Speed=4Gb
Changes the port speed of an FC SAN connection
->set fc-connection BlueProfile 1 BootPriority=Primary
BootPort=50:06:0B:00:00:C2:62:00 BootLun=5
Changes the SAN boot priority and sets additional boot parameters
Item Description
show fc-connection Display the FC SAN connections associated with the server profiles.
Syntax
show fc-connection [<ConnectionID>]
Parameter
ConnectionID
(optional)
The ID of an existing FC SAN connection. The ID format is <ProfileName:Port>.
Use <ProfileName:*> to display all FC SAN connections of a profile. Use "*" to
display all FC SAN connections in the domain.
Examples
->show fc-connection
Displays all FC SAN connections in the domain