HP Virtual Connect 8Gb 24-port Fibre Channel Module for c-Class BladeSystem - Manual (Page 55)

Command line 55
Item Description
show
link-dist-interval
Display the FC login re-distribution interval for uplinks that are part of a fabric
configured for Automatic login redistribution.
Syntax
show link-dist-interval
Example
->show link-dist-interval
Displays the FC login re-distribution interval
lldp
Display LLDP information received on a specified port.
Supported actions: help, show
Item Description
show lldp Display LLDP information received on the specified port.
Syntax
show lldp <PortID>
Parameter
PortID (required) The port ID of the port for which to display LLDP information. PortID is composed
of <EnclosureID>:<BayNumber>:<PortLabel>.
A listing of the possible uplink PortIDs can be obtained by entering the show
uplinkport command. Module downlink PortLabel's range from d1 through
d16, depending on the enclosure configuration.
Example
->show lldp enc0:1:X1
Displays LDAP information received on port X1 of the module in bay1 of
enclosure enc0
log-target
Manage remote log destination settings.
Supported actions: add, help, remove, set, show, test
Item Description
add log-target Add a new remote log destination.
Syntax
add log-target <Destination=IPv4Address|DNS>
[Severity=<Critical|Error|Warning|Info>]
[Transport=<TCP|UDP>] [Port=<1-65535>]
[Security=<None|STunnel>] [Format=<RFC3164|ISO8601>]
[State=<Enabled|Disabled>]
Properties
Destination
(required)
The IPv4 address or the DNS name of the remote log destination
Severity (optional) The severity of the log messages that should be sent to the specified destination.
Valid values include "Critical", "Error", "Warning", and "Info". The default value
is "Info".
Transport (optional) The transport protocol to be used for sending the log messages to the destination.
Valid values include "TCP" and "UDP". The default value is "UDP".