HP Designjet 4000 Printer series - Manual (Page 212)

Front panel message Suggested action
Right edge not found. The printer cannot locate the right–hand edge of
the paper, the paper may be badly positioned.
Press the Select key and try to load the roll again.
Sheet edge not found. The printer cannot locate the edges of the paper,
the paper may be badly positioned. Press the
Select key and try to reload the sheet.
Paper not found. During the paper load process the printer did not
detect any paper. Press the Select key to retry.
Paper loaded with too
much skew. During the paper load process the printer detected
that the paper had too much skew. Press the
Select key to try to load the paper again.
Paper too small. During the load process the printer detected that
the paper is too narrow or too short to be loaded in
the printer. Press the Cancel key to stop the load
process. See “Tell me about functional
specifications” on page 239.
Paper too big During the load process the printer has detected
that the paper is either too wide or too long (sheet
only) to be loaded properly. Press the Cancel key
to stop the load process. See “Tell me about
functional specifications” on page 239.
Sheet too long. During the load process the printer has detected
that the sheet is too long to be loaded properly.
Make sure that the printer expects sheet and not
roll. Press the Select key to try to load the paper
again. See “Tell me about functional
specifications” on page 239.
Lever lifted. During the load process the blue paper load lever
was lifted. This prevents the printer from loading
the paper. Press the Select key to load the paper
again.
Chapter 16
210
The
problem
is w
ith the
paper