HP Designjet 4000 Printer series User Manual
Page 82
The spindle has a stop at each end to keep the roll in position. The stop at the left-
hand end can be removed to mount a new roll, it slides along the spindle to hold
rolls of different widths.
4.
Remove the blue paper stop (1) from the left-hand end of the spindle.
5.
If your roll has a three-inch cardboard core, ensure that the core adaptors
supplied with the printer have been installed. See below:
6.
The roll may be very long; rest the spindle horizontally on a table and load the roll
on the table. Bear in mind that you may need two people to handle it.
7.
Slide the new roll onto the spindle. Make sure the paper type is oriented as
shown. If it is not, remove the roll, turn it 180 degrees and slide it back on to the
spindle.
Note
There is also a label on the spindle showing the correct orientation.
Chapter 5
80
How
do
I handle
paper?