HP Designjet 4000 Printer series - Manual (Page 24)

How do I attach the stand to the printer?
1. You now need to identify the left and right of the printer. This information is shown
on the foam end packs. Also identify the rear of the printer.
2. Pull open the protective plastic from the base of the printer. Please ensure that
there is a three-meter space clear of obstructions to the rear of the printer.
Remove the two desiccant bags from the printer.
3. In this step, make sure you position the stand pins in the holes in the center of the
printer body brackets.
Chapter 2
22
How do
I assemble
the
printer?