Setup overview – HP Tower Uninterruptible Power System User Manual
Page 17
Overview 17
Setup overview
To setup HPPP:
1.
Visit the HP website
to download the latest version of HPPP.
2.
Connect all equipment powered by the UPS to the receptacles on the UPS rear panel. If the UPS has
multiple load segments, note which load segment powers each device.
3.
Power up the UPS and all attached equipment.
4.
Be sure that the serial or USB cable connecting the UPS to the HPPP is properly installed.
5.
Install the HPPP Administrator or Client software according to the instructions for your operating system.
If the configuration does not contain an HP UPS Network Module, there must be one HPPP Administrator
for each UPS.
6.
Browse to the HPPP Administrator or Client.
7.
Configure the power source on the Device Discovery screen (on page
) for both the HPPP
Administrator and the Client. Be sure to configure the Administrator power source before configuring
the Client.
8.
Configure the power fail settings on the Shutdown Parameters screen (on page
9.
Test shutdown.
10.
Configure event actions on the Event Actions screen (on page
11.
Configure user accounts on the User Accounts screen (on page
12.