HP LaserJet P3005 Printer series - Manual (Page 151)

Specks might appear on a page after a jam has been cleared.
1. Print a few more pages to see if the problem corrects itself.
2. Clean the inside of the device and run a cleaning page to clean the fuser. (See Clean the paper
path .)
3. Try using a different type of media.
4. Check the print cartridge for leaks. If the print cartridge is leaking, replace it.
Dropouts
1. Make sure that the environmental specifications for the device are being met. (See Operating
environment .)
2. If the media is rough, and the toner easily rubs off, open the CONFIGURE DEVICE menu at the
device control panel. Open the PRINT QUALITY submenu, select FUSER MODES, and then select
the media type you are using. Change the setting to HIGH1 or HIGH2, which helps the toner fuse
more completely onto the media. (See
Print Quality submenu .)
3. Try using a smoother media.
Lines
A
A
A
A
A
B
B
B
B
B
C
C
C
C
C
a
a
a
a
a
c
c
c
c
c
b
b
b
b
b
1. Print a few more pages to see if the problem corrects itself.
2. Clean the inside of the device and run a cleaning page to clean the fuser. (See Clean the
device .)
3. Replace the print cartridge.
ENWW Solve print-quality problems 139