HP LaserJet P3005 Printer series - Manual (Page 57)

3. Press to highlight I/O, and then press .
4. Press to highlight EMBEDDED JETDIRECT, and then press .
5. Press to highlight TCP/IP, and then press .
6. Press to highlight IPv4 SETTINGS, and then press .
7. Press to highlight CONFIG METHOD, and then press .
8. Press to highlight MANUAL SETTINGS, and then press .
9. Press to highlight SUBNET MASK, and then press .
10. Press the or arrow to increase or decrease the number for the first byte of the subnet mask.
11. Press to move to the next set of numbers. (Press to move to the previous set of numbers.)
12. Repeat steps 10 and 11 until the correct subnet mask is complete, and then press to save the
subnet mask.
13. Press Menu to return to the Ready state.
Set the default gateway
1. Press Menu .
2. Press to highlight CONFIGURE DEVICE, and then press .
3. Press to highlight I/O, and then press .
4. Press to highlight EMBEDDED JETDIRECT, and then press .
5. Press to highlight TCP/IP, and then press .
6. Press to highlight IPv4 SETTINGS, and then press .
7. Press to highlight CONFIG METHOD, and then press .
8. Press to highlight MANUAL SETTINGS, and then press .
9. Press to highlight DEFAULT GATEWAY, and then press .
10. Press the or arrow to increase or decrease the number for the first byte of the default
gateway.
11. Press to move to the next set of numbers. (Press to move to the previous set of numbers.)
12. Repeat steps 10 and 11 until the correct default gateway is complete, and then press to save
the default gateway.
13. Press Menu to return to the Ready state.
Disable network protocols (optional)
By factory default, all supported network protocols are enabled. Disabling unused protocols has the
following benefits:
● Decreases printer-generated network traffic
● Prevents unauthorized users from printing to the printer
ENWW Network configuration 45