HP LaserJet P3005 Printer series - Manual (Page 47)

5. Press or to select the desired option, and then press .
6. Press Menu to exit the menu.
Tray-behavior options
Four user-defined options are available for tray behavior:
● USE REQUESTED TRAY. Selecting EXCLUSIVELY ensures that the device does not
automatically select another tray when you indicate that a specific tray should be used.
Selecting FIRST allows the device to pull from a second tray if the specified tray is empty.
EXCLUSIVELY is the default setting.
● MANUALLY FEED PROMPT. If you select ALWAYS (the default value), the system always shows
a prompt before pulling from the multipurpose tray. If you select UNLESS LOADED, the system
displays the prompt only if the multipurpose tray is empty.
● PS DEFER MEDIA. This setting affects how non-HP PostScript drivers behave with the device.
You do not need to change this setting if you use the drivers that HP supplies. If set to
ENABLED, non-HP PostScript drivers use the same HP tray selection method as the HP drivers.
If set to DISABLED, some non-HP PostScript drivers use the PostScript tray selection method
instead of the HP method.
● SIZE/TYPE PROMPT. Use this item to control whether the tray configuration message and its
corresponding prompts are shown whenever a tray is opened and closed. These prompts instruct
you to change the type or size if the tray is configured for a different type or size than is loaded in
the tray.
Set tray behavior option
1. Press Menu to open the menus.
2. Press to highlight CONFIGURE DEVICE, and then press .
3. Press to highlight SYSTEM SETUP, and then press .
4. Press to highlight TRAY BEHAVIOR, and then press .
5. Press to select the tray behavior option.
6. Press or to select the desired option, and then press .
7. Press Menu to exit the menu.
Sleep Delay
The adjustable Sleep Delay feature reduces power consumption when the device has been inactive for
an extended period. Use this menu item to set the length of time before the device goes into Sleep
mode. The default setting is 30 MINUTES.
NOTE The device control-panel display dims when the device is in Sleep mode. Sleep mode
does not affect device warm-up time unless the device was in Sleep mode for more than 8 hours.
ENWW Change device-control-panel configuration settings 35