HP LaserJet P3005 Printer series - Manual (Page 43)

I/O submenu
Items on the I/O (input/output) menu affect the communication between the device and the computer.
If the device contains an HP Jetdirect print server, you can configure basic networking parameters by
using the submenu. These and other parameters can also be configured through HP Web Jetadmin
(see
Use HP Web Jetadmin software ) or other network configuration tools, such as the embedded Web
server (see Use the embedded Web server ).
Item Values Explanation
I/O TIMEOUT 5 to 300 Select the I/O timeout period in seconds.
Use this setting to adjust timeout for the best performance. If
data from other ports appears in the middle of your print job,
increase the timeout value.
The default setting is 15.
PARALLEL INPUT HIGH SPEED
ADVANCED FUNCTIONS
HIGH SPEED: Select YES to enable the device to accept the
faster parallel communications that are used for connections
with newer computers.
ADVANCED FUNCTIONS: Turn the bidirectional parallel
communication on or off. The default is set for a bidirectional
parallel port (IEEE-1284).
The device uses this setting to send status messages to the
computer. Turning the parallel advanced functions on might
slow language switching.
EMBEDDED JETDIRECT TCP/IP
IPX/SPX
APPLETALK
DLC/LLC
SECURITY
DIAGNOSTICS
LINK SPEED
PRINT PROTOCOLS
TCP/IP: Select whether the TCP/IP protocol stack is enabled
or disabled. You can set several TCP/IP parameters.
In addition, select TCP/IP to configure IPv4, IPv6, and other
TCP/IP settings.
IPX/SPX: Select whether the IPX/SPX protocol stack (in
Novell NetWare networks, for example) is enabled or disabled.
APPLETALK: Enable or disable an AppleTalk network.
DLC/LLC: Select whether the DLC/LLC protocol stack is
enabled or disabled.
SECURITY: Print or manage network security settings.
DIAGNOSTICS: Use tests to help diagnose network hardware
or TCP/IP network connection problems.
LINK SPEED: Select the network link speed and
communications mode for the 10/100T print server. To ensure
proper communication, the Jetdirect settings must match
those of the network.
PRINT PROTOCOLS: Prints the settings for IPX/SPX, Novell
Netware, AppleTalk, and DLC/LLC protocols.
ENWW Configure Device menu 31