HP Library and Tape Tools - Manual (Page 38)

3 Using L&TT on non-Windows systems
•
“Installation” (page 38)
•
“Using the command screen interface (CSI)” (page 41)
•
“Managing firmware” (page 47)
•
“Running the tests (CSI)” (page 50)
•
“Using reports and support tickets” (page 54)
Installation
•
“Installing L&TT for Linux” (page 38)
•
“Installing L&TT for HP-UX” (page 39)
•
“Installing L&TT for HP VMS” (page 40)
•
“Installing L&TT for Solaris” (page 40)
•
“Installing L&TT for Mac” (page 41)
Installing L&TT for Linux
Linux installation prerequisities
Software dependencies/prerequisites
Device must be recognized by proc/SCSI subsystem.
•
•
Device drivers for the connected tape devices/libraries
or default device driver must be present.
•
To install L&TT, you must first uninstall any previous
versions.
Unistalling previous versions
Before installing L&TT on Linux, you must first uninstall any previous versions. To determine if L&TT
is already installed, use the following command:
rpm -qa | grep ltt
To remove a previous version of L&TT, use the following command:
rpm -e ltt
38 Using L&TT on non-Windows systems