HP Library and Tape Tools - Manual (Page 82)

•
Drive Test Option —If the Drive Load test is enabled, specify one of the following options:
Off ◦
◦ Data loop back (default)
◦ Read-only
◦ Read/write
•
Cartridge Load Test —Specify one of the following options for the Cartridge Load test:
Off (default) ◦
◦ Single drive
◦ Multiple drives
◦ All drives
•
CM Integrity Mode —Specify whether to enable the CM integrity check option for LTO
drives. The default setting is on.
Library Read Write test
Table 11 Library Read Write test details
Library Read Write test Details/Library specific test
The Library Read Write test automates the testing of the drives and tapes in a tape
library. This test assumes that the library robotics are working properly. To test the
library robotics, use
“Library Exerciser test” (page 79) or “Move test” (page 90) .
Description
For instructions on how to perform this test, “Running tests and device-specific utilities”
(page 29) or “Running the tests (CSI)” (page 50) .
Run this test to verify that the tapes and drives are functioning properly. When to run
Highly dependent on the library being tested and the options selected. Duration
82 Tests