HP Library and Tape Tools - Manual (Page 79)

Table 9 LTO Data Assessment test (continued)
LTO Data Assessment test Details/Media specific test
Time taken (Avg) Data Verified Test Option Tape Generation
Duration
5 Minutes 39 GB Quick LTO-6
55 Minutes 500 GB Moderate LTO-6
5 Hours 2.5 TB Full LTO-6
5 Minutes 38 GB Quick LTO-5
45 Minutes 300 GB Moderate LTO-5
4 Hours 30 Minutes 1.5 TB Full LTO-5
5 Minutes 30 GB Quick LTO-4
26 Minutes 160 GB Moderate LTO-4
2 Hours 20 Minutes 800 GB Full LTO-4
4 Minutes 19 GB Quick LTO-3
18 Minutes 80 GB Moderate LTO-3
1Hour 30 Minutes 400 GB Full LTO-3
All LTO drives Available for
Library Specific tests support ticket
•
“Library Exerciser test” (page 79)
•
“Autoloader Exerciser test” (page 110)
•
“Library Read Write test” (page 82)
•
“ESL Vendor ID test” (page 85)
Library Exerciser test
Table 10 Library Exerciser test details
Library Exerciser test Details/Library specific test
This is a general-purpose test of the library. The test exercises the library robotics by
moving media to and from all of the selected elements in the library. There are two Description
versions of this test, depending on the library model. This test can be stopped before
it completes. To abort the test from the GUI, click Abort Test. To abort the test from the
CSI, use the Ctrl-A key combination.
CAUTION: When run on the MSL, ESL, and EML series libraries, this test does NOT
overwrite data. However, on other libraries, this test may overwrite data depending
on how the test options are configured.
Run this test to verify that the library is functioning properly. When to run
Highly dependent on the library being tested and the options selected. Duration
The following options are available for this test: Options
•
Perform inventory at start of test— By default, this option is set to False because the
inventory operation can take a long time on large libraries. If the inventory
Diagnostic tests 79