HP Library and Tape Tools - Manual (Page 89)

Table 18 Device Configuration test details (continued)
Device Configuration test Details/Other test
Options •
Enable/Disable Data Compression—Specify enabled or disabled to enable or
disable data compression on the drive. Specify leave unchanged to retain the
current data compression setting.
•
Prevent/Allow Media Removal—Specify prevent or allow to prevent or allow media
removal from the drive. Specify leave unchanged to retain the current setting.
• Enable ODBR—This option is only available for some DDS drives. For DDS, device
analysis will indicate whether or not there is a need to enable OBDR using the
Device Configuration test.
All drives supported by L&TT. Available for
Device Self-test
Table 19 Device Self-test details
Device Self-test Details/Other test
This test executes the internal self-test of the device and reports any failures. This test
is useful in confirming that the device itself is operating properly. Not all devices
support an internal self-test. Description
NOTE:
•
If no options are specified, L&TT runs the test with looping options set to Count
based loop with a looping value of 1.
• Test will not overwrite any data on media present in the drive.
•
For instructions on how to perform this test, see “Running tests and device-specific
utilities” (page 29) or “Running the tests (CSI)” (page 50) .
•
Command line syntax—The Device Self-test is available from the command line.
For more information, see
“Running tests (CLF)” (page 64) .
Run this test as a quick check of the integrity of the device. When to run
< 1 minute Duration
Options •
Looping options—Specify Count based loop or Time based loop(min). In either
case, the actual value is entered separately using the Looping value parameter.
Example 3 To set a time-based loop of 10 minutes:
testopt=”Looping Options:Time based loop(min)”
testopt=”Looping value:10”
•
Looping value—Specify an integer greater than zero.
Example 4 To set a count-based loop to iterate five times:
testopt=”Looping Options:Count based loop”
testopt=”Looping value:5”
AIT, DDS, DLT, SDLT, VS80/VS160 or DLT1, LTO autoloaders and drives, ESL, MSL,
C7200, C7145, C5177, C1194F, C5151, C5173, C6280, SSL 1016 and STK Available for
libraries, STK 9840 drives, MO drives & libraries, and A6356A Fibre Channel
management card.
Diagnostic tests 89