HP Library and Tape Tools - Manual (Page 40)

Installing L&TT for HP VMS
HP VMS installation prerequisites
Software dependencies/prerequisites L&TT requires the following patches or higher to run
successfully:
•
V7.3–2 Alpha
VMS732_FIBRE_SCSI-V0800VMS732_UPDATE-V0500
•
V8.2 Alpha VMS82A_FIBRE_SCSI-V0100
VMS82A_UPDATE-V0200
•
V8.2 Itanium VMS821_FIBRE_SCSI-V0100
VMS821_UPDATE-V0200
Unistalling previous versions
To determine whether L&TT is already installed on the system, use the following command:
$ Product show product ltt
To remove a previous version of L&TT, use the following command:
$ product remove ltt
Installation procedure for HP VMS
NOTE: L&TT is supported from VMS v7.3-2 onwards and is supported on both ODS-3 and ODS-5
file systems.
1. Download or copy the L&TT .zipexe file to a temporary directory.
2. Navigate to the directory you copied the install file to and enter the following commands to
install L&TT:
$ run hp-axpvms-ltt-v<xx>-1.zipexe (where <xx> is the version number) (alpha
platforms) $ product install ltt. The installation procedure creates the directory structure
opt.ltt
in sys$sysdevice:[vms$common] and installs all the required files for L&TT.
Passing an alternate installation location via the /destination parameter will override the
default installation location, allowing installation on a non-system disk. $ product install
ltt /destination=<yyy>
(where <yyy> is the preferred installation directory). To run
L&TT, use: $ @sys$startup:ltt$startup.com
Installing L&TT for Solaris
Solaris installation prerequisites
•
The device must be shown in the cfgadm –al and prtconf –v command output.
•
The device driver for connected tape drives and libraries or the default device driver must be
present.
Installation and uninstallation
To install the L&TT package:
1.
Login as root.
2. Navigate to the temporary directory:
cd /tmp
40 Using L&TT on non-Windows systems