HP Library and Tape Tools - Manual (Page 93)

Restore Factory Default Settings test
Table 25 Restore Factory Default Settings test details
Restore Factory Default Settings test Details/Other test
Checks current configuration parameters of an MO drive and identifies any that differ
from factory defaults. If any differences are detected, the test can reset to factory
defaults. Description
NOTE: For instructions on how to perform this test, see “Restore Factory Default
Settings test” (page 93) or “Running the tests (CSI)” (page 50) .
Device Analysis test results will recommend running this test if abnormal (not default)
settings are detected. Abnormal settings do not necessarily mean there is a need to When to run
set them to default values. For example, the user may want certain drive settings to be
different from the default values; in that case it is better not to run this test. However,
you may also want to try restoring defaults when you suspect configuration parameters
that could be adversely impacting operation may have been changed.
Average duration < 1 minute. Duration
4X, 8X, and 14X MO drives. Available for
After the test or utility completion, the result log file location is displayed in the test/utility results
tab as shown in
Figure 33 (page 93) (Windows system) and Figure 34 (page 94) (non-Windows
system).
Figure 33 Result log file location in Windows system
Diagnostic tests 93