Ag Leader GPS 5200 User Guide - Manual (Page 27)

GPS 5200 Receiver User Guide 25
Installing the Receiver 3
Connecting to an external device
After installing the receiver and connecting the appropriate cabling, you
can connect the receiver to various external devices. For example:
To convert the GPS 5200 receiver to a 12-pin conxall cable, use the
adapter cable (P/N 50581).
Note – Do not bend the cable at the Deutsch connector. When you secure
the cable, use the supplied P-Clip. The P-Clip provides additional support
to the connectors and reduces the risk of damage.
To connect the GPS 5200
receiver to ... use the cable ...
an Autopilot system P/N 50165
(this cable has no DB9 connector)
a Field computer P/N 50166
a Yield monitor P/N 50166
a Trimble SiteNet™ radio, for RTK
positioning P/N 49801
Plug the ... into ...
Deutsch 12-pin connector Port A on the back of the receiver
straight DB9-pin connector the external device
power connectors a power supply
GPS5200_1A_UserGuide_ENG.book Page 25 Friday, December 19, 2008 12:57 PM