Ag Leader GPS 5200 User Guide - Manual (Page 54)

5 Troubleshooting
48 GPS 5200 Receiver User Guide
AgRemote utility
FlashLoader 200 upgrade utility
Problem Possible solution
AgRemote cannot communicate
with the receiver. All you see is a
blank screen. 1. Make sure that:
• the receiver is connected to a 12–32 V DC
power source
• all cable connections between the receiver
and the computer are secure
• you are using the correct COM port
2. Turn off the receiver then turn it on again.
3. Select File / Connect.
Problem Possible solution
The FlashLoader 200 upgrade utility
cannot detect the receiver or
download the firmware. Make sure that:
• Other programs, such as AgRemote and
Microsoft® ActiveSync® technology, are not
using the COM port that the computer is using.
• The receiver is connected to a 12–32 V DC power
source.
• All cables are connected correctly between the
device and the computer.
• The receiver is connected to the correct computer
COM port. To do this:
1. From the FlashLoader 200 menu, select Settings.
2. Select the check box for a serial link.
3. At Port, select Auto. Click OK .
4. Select the Upload firmware to receiver check
box.
5. Navigate to where the firmware file is saved and
select the file. Click Proceed .
6. From the Auto Port Select dialog, select Use
receiver on port... and click OK .
Once you have checked this, turn off the receiver
then turn it on again. Try again to connect
FlashLoader 200.
GPS5200_1A_UserGuide_ENG.book Page 48 Friday, December 19, 2008 12:57 PM