Ag Leader GPS 5200 User Guide User Manual
Page 37
GPS 5200 Receiver User Guide
35
Configuring the Receiver
4
To enable WAAS reception in the field:
1.
Take the receiver outside. Make sure that it has a clear southeast
and southwest view of the sky.
2.
Turn on the receiver. WAAS activation can take two or more
minutes. Once activation succeeds, the Home screen displays
D/3D
:
Configuring the GPS 5200 receiver to operate in RTK
mode
Use the AgRemote utility to configure the GPS 5200 receiver for
operation in RTK mode. To configure the receiver:
1.
Connect the GPS 5200 receiver to the computer. Turn on the
receiver and start the AgRemote utility.
2.
In AgRemote, select Configuration / DGPS Config.
3.
Set the Source Select field to RTK.
4.
Press
then
to complete this part of the procedure.
5.
For RTK operation, connect the radio to a port. Change the port
input settings for that port to RtkLnk.
GPS5200_1A_UserGuide_ENG.book Page 35 Friday, December 19, 2008 12:57 PM