Ag Leader GPS 5200 User Guide - Manual (Page 33)

GPS 5200 Receiver User Guide 31
C H A P T E R
4
Configuring the Receiver
4
In this chapter:
 AgRemote Home screen
 Configuring Differential
GPS
 Configuring the GPS 5200
receiver to operate in RTK
mode
 Configuring the
communication ports
Use either the Autopilot interface or the
AgRemote utility to change configuration
settings in the GPS 5200 receiver. You will
need to configure the receiver if you
connect to a third-party device, for
example.
• If an Autopilot system is configured
to use a GPS 5200 receiver, and the
port on the receiver is set to
8-N-1 38.4 K, the Autopilot system
automatically configures the
receiver.
• The AgRemote utility is available
from the Ag Leader website
(
www.agleader.com ). This chapter
describes how to use the utility to
perform some common
configurations.
Note – OmniSTAR VBS and HP are
subscriber services that need to be
activated. For more information, see
OmniSTAR, page 33 .
GPS5200_1A_UserGuide_ENG.book Page 31 Friday, December 19, 2008 12:57 PM