Ag Leader GPS 5200 User Guide - Manual (Page 40)

4 Configuring the Receiver
38 GPS 5200 Receiver User Guide
with some other devices and software programs, the receiver port
communication settings must be 8-N-1 NMEA 4800. If AgRemote has
changed the settings, you will need to change them back manually.
When using a Trimble SiteNet 900 radio, make sure that the
communication settings are correct in the receiver.
The default settings to use with the SiteNet radio are:
Changing the input or output port settings
1. From the Port A Config
screen, press
 until the
Port-A Input/Output
screen appears.
2. Press  to activate the cursor.
3. Press  or  to change the value.
4. Press  .
5. Repeat Steps 3 and 4 until you have set all the required values.
6. Press  to save all the changes.
7. Press  to move to the next screen.
Setting Description
Baud rate 38,400
Data bits 8
Parity None
Stop bits 1
åæ I RTCM 9600
8N1 0 NMEA 4800
GPS5200_1A_UserGuide_ENG.book Page 38 Friday, December 19, 2008 12:57 PM