Innovate Motorsports LM-2 - Manual (Page 28)

Document # 31-0008 LM2_Manual_1.3.doc 28
2. Select OBD-II and press the Enter button.
3. Select Clear DTC Codes and press the Enter button.
4.8 Check and Clear Vehicle Trouble Codes with LM Programmer
1. Connect the LM-2 to the vehicle via the OBD II connector.
2. Power up the LM-2.
3. The LM Programmer application can be launched from Start->Programs-
>LogWorks3->LM Programmer from the Windows task bar. A small dialog box
will appear indicating that the program is looking for connected Innovate Devices,
then the main dialog should appear.
4. Click the tab labeled “Trouble Codes.”
Standard Trouble Codes are listed both with a number and a description. Manufacturer
specific codes will generally just appear as a number, though sometimes, the general
category can be identified.
You can request that the ECU clear the pending codes using the Clear and Refresh
button at the bottom right corner of the page.
Note: On some vehicles, the ignition must be on, but the vehicle not started, for the
Clear DTC request to be accepted.