Innovate Motorsports LM-2 - Manual (Page 6)

Document # 31-0008 LM2_Manual_1.3.doc 6
During Recording, an upper case ‘R’ and a counter will display on the lower left:
Counting minutes and seconds of recording.
Similarly, during playback a upper case ‘P’ and a counter will display:
Counting elapsed time during playback.
Note: If Recording does not start (see later section), also look here, the word “Card?”
will appear if no SD card is detected when Record is selected. The word “Full!” will
appear if you have either filled the SD card, or exhausted the available log names (see
section on recording).
Moving to the right, the next two indications are O2 sensor status, which can be one of
the following:
HW - Heater Warm-up
Cal - Calibrating
O2 - Reading O2 context (lambda over 8.something)
L - Reading Lambda (or AFR)
Ex - Error, Check Appendix E for error code meanings and trouble shooting tips
Note: If the LM-2 is a single channel model, the second indication will be blank, not an
error code.
The next indicator, “R”, will appear when a) RPM is selected for logging/use (see
menus) and b) an RPM signal is detected. Note, when RPM is enabled, but no RPM
signal is detected, this symbol will appear in lower case (“r”).
The “A” indicator means that the 4 Analog Inputs are selected for logging/Use (see
menus). It is all or nothing. The display will be blank if disabled.
The “O” indicates that an OBD-II connection is active. This indicator will blink at the
relative ‘sample rate’, which will vary on the number of channels selected and the
vehicle’s protocol. The display will be blank if the unit is not connected to an OBD-II port.
The blinking “M” indicates that MTS serial data is being generated. This will blink at the
relative MTS packet rate (for comparison with the O indicator). If the unit is not the
“head” unit, then this will only blink when packets are being received via the Serial In