Innovate Motorsports LM-2 - Manual (Page 34)

Document # 31-0008 LM2_Manual_1.3.doc 34
5.3 Analog Outputs
5.3.1 Programming the analog outputs
1. Connect the LM-2 to your computer with the provided USB cable.
2. Power up the LM-2.
3. Launch LM Programmer. The LM Programmer application can be launched from
Start->Programs->LogWorks3->LM Programmer from the Windows task bar.
4. Select one of the Analog output tabs. The Analog output page looks like this:
This shows the analog output voltages versus Lambda for one of the two analog outputs.
The graph display is automatically scaled to the selected voltages. For each output you
can specify a minimum and maximum lambda value and the associated voltages. Below
the minimum and above the maximum lambda values the output voltages stay constant
at the associated programmed voltage.
By selecting the ‘use Air-Fuel-Ratio’ button you can program the curve by AFR instead
of Lambda. This does not change the programming, only the representation of the data.
When programming by AFR the LM Programmer converts the number to Lambda
before programming the LM-2.
Click the ‘Program’ button to download the new data into the LM-2. Once the unit is
programmed the ‘Program’ button will grey out.