JKS 9903 - Manual (Page 3)

JKS 9903 JKS Body Lift Installation Page 3
‰ 4. INSERT BODY PUCKS
 Position a hydraulic jack next to body mount 3 on
DRIVER SIDE of vehicle.
 Place a sturdy wooden block between the hydrau-
lic jack pad and channel portion of vehicle body for
protection.
 Carefully raise the vehicle body just enough to
insert the 1.25” Body Pucks (A) between body and
factory body mounts
2 3 4 5 and 6 .
NOTE: Position Body Pucks with recessed bottom
encapsulating the OE body mount.
 Locate the factory rubber radiator bumper be-
neath the grill panel and replace with the supplied
Extended Radiator Bumper (F) using the original
hardware.
 With Body Pucks (A) and Extended Radiator
Bumper (F) inserted, slowly lower the vehicle body
onto mounts, ensuring correct alignment of body
on chassis.
 Apply medium strength thread locking compound
to three of the supplied 1/2” x 4-1/2” Bolts (B) and
two of the 7/16” x 4” Bolts (D).
 Insert the 1/2” x 4-1/2” Bolts (B) with 1/2” Flat
Washers (C) into body mount positions
2 3 and
4 . Insert the 7/16” x 4” Bolts (D) with 7/16” Flat
Washers (E) into body mount positions 5 and 6 .
Start threads but DO NOT TIGHTEN bolts until
instructed.