JKS OGS170 - Manual (Page 3)

JKSOGS170 JKS Rear Tackbar Relocation Bracket Installation Page 3
 Secure the original track bar mounting bolt with the
original flag nut. Do not tighten bolt yet.
 Raise extension tab on Riser Brace (B) until flush
against side of Relocation Bracket (A). The two
mounting holes on extension tab should align
with corresponding holes on side of Relocation
Bracket.
 Place a 3/8” Flat Washer (G) onto each of the
supplied 3/8” x 1” Bolts (F). Insert a 3/8” Bolt with
Washer into both holes on side of Relocation
Bracket (A) and through mounting holes on exten-
sion tab of Riser Brace (B).
 Bolts must be installed from the inside of bracket
with threaded ends facing left side of vehicle.
 Place another 3/8” Flat Washer (G) onto threads of
3/8” x 1” Bolt (F) along with a 3/8” Ovalok Nut (H).
Do not tighten bolts yet.
 Using a torque wrench, tighten the original track
bar mounting bolt to 125 ft-lbs.
 Tighten the 1/2” Nylock Nuts (E) on U-Bolt (C) to
65 ft-lbs.
 Tighten both 3/8” Ovalok Nuts (H) on Riser Brace
extension tab to 40 ft-lbs.
‰ 3. RE-INSTALL REAR TRACK BAR
 Slide axle end of rear track bar into pocket of Relo-
cation Bracket (A). Make sure track bar aligns with
mounting hole in bracket. HINT: If track bar does
not align with mounting hole, slowly raise or lower
hydraulic jack supporting axle until holes align.
 Secure rear track bar to Relocation Bracket (A)
by inserting supplied M14 x 80mm Bolt (I) through
mounting hole. Bolt must be installed from the
front to the rear of the vehicle.
 Thread M14 Nylock Nut (J) onto M14 x 80mm Bolt
(I). Do not tighten nut yet.
 Remove jack stands and lower vehicle to ground.
HINT: Vehicle must be at normal ride height, on
level ground, with the suspension supporting the
full vehicle weight.