ADC Gas Electric Steam WDA-540 - Manual (Page 34)

32
D. PROGRAM LOCATION 01 (PL01)
(No Cycle In Progress)
and/or
(Amount To Start)
To enter program mode, close program switch.
(Dryer Temperature Display)
Press “Perm Press” key. Display will read
“PL01,” program location 01. Press “Perm Press”
key. Display will read temperature conversion
status, either Fahrenheit or Celsius. If no change,
press “Perm Press” key. Should a change be
necessary, press “HI” or “LO” key and then press
“Perm Press” key.
Display will read timing status,
(timed or automatic). If no change,
press “Perm Press” otherwise press
“HI” or “LO” key and then “Perm
Press” key.
or
or
or
or
HI Temp
°FAr
LO Temp
°FAr
°CEL
LO Temp
AUtO tInE
°CEL
Perm Press
HI Temp
AUtO
tInE
HI Temp
LO Temp
LO Temp
HI Temp
Perm Press
Perm Press
70F
FILL 25
Continue
PL01
(Close Program Switch)