ADC Gas Electric Steam WDA-540 - Manual (Page 51)

49
Location to be viewed/changed.
Press “Perm Press” key.
Display will read “GdLY,” guard delay
time for 3-seconds and then time
programmed. If no change, press “Perm
Press” key, otherwise press “HI” or “LO”
keys and then “Perm Press” key.
R. PROGRAM LOCATION 15 (PL15)
Anti-Wrinkle Timing
Summary: Guard delay time is programmable from 1 to 9 minutes. Guard on time is programmable from
1 to 99-seconds.
Time Increase Time Decrease
Time Increase Time Decrease
PL15
GdLY
Perm Press
2 HI Temp
Perm Press
LO Temp
Refer to Section V for instructions
on entering program locations.
(Wait 3-Seconds)
20
("Hold In" to Accelerate) ("Hold In" to Accelerate)
LO Temp HI Temp
Perm Press
PL16
Proceed to next location
to be changed
To exit program mode,
open program switch
("Hold In" to Accelerate) ("Hold In" to Accelerate)
Gont
(Wait 3-Seconds)
Display will read “Gont” anti-wrinkle
on time for 3-seconds and then time
programmed. If no changes, press “Perm
Press” key, otherwise press “HI” or “LO”
keys and then “Perm Press” key.