ADC Gas Electric Steam WDA-540 - Manual (Page 49)

47
Location to be viewed/changed.
Press “Perm Press” key.
Display will read “AFAt,” amount for
additional time (ACOn mode only) for
3-seconds and then amount programmed.
If no change, press “Perm Press” key,
otherwise press “HI” or “LO” keys and
then “Perm Press” key.
P. PROGRAM LOCATION 13 (PL13)
Coin Accumulation Minimum Amount for More Time
Summary: The amount to start is programmable from 1 to 9999.
Amount Decrease Amount Increase
PL13
AFAt
Perm Press
10 HI Temp
Perm Press
LO Temp
Refer to Section V for instructions
on entering program locations.
(Wait 3-Seconds)
("Hold In" to Accelerate) ("Hold In" to Accelerate)
PL14
Proceed to next location
to be changed
To exit program mode,
open program switch