ADC Gas Electric Steam WDA-540 - Manual (Page 6)

4
SECTION I
INTRODUCTION
The Phase 5 Coin Computer System is a fully programmable, highly sophisticated dryer control system.
American Dryer Corporation has designed the Phase 5 coin microprocessor controller (computer) to be the
most versatile and reliable coin-operated control system available.
To eliminate as many moving parts as possible, ALL Phase 5 coin microprocessor controller (computer)
programming is done through the membrane switch on the front of the control panel. The Program Switch (PS)
that puts microprocessor controller (computer) into the program mode is a single program switch. This program
switch eliminates the possibility of switch failure due to an accumulation of lint or moisture.
Phase 5 Coin Microprocessor Controller (Computer) Features
AUTOMATIC PROGRAM REVIEW
In the program mode, the Phase 5 coin microprocessor controller (computer) will show ALL settings by one (1)
touch of the low temperature keyboard (touch pad) selection.
PROGRAMMABLE
Changes in the programs are made at the temperature keyboard (touch pad) selection and actual programs are
displayed for verification.
ADJUSTABLE TIME
Programmable from a minimum of 1 minute to a maximum of 99 minutes in 1 minute increments.
COIN ACCEPTOR DENOMINATIONS
Values of coin acceptors are programmable from a minimum of 1 to a maximum value of 9999 for any U.S. or
foreign coin denomination.
AMOUNT TO START
Programmable from a minimum value 1 to a maximum value of 9999 in increments of one (1).
ACCUMULATIVE TIME
This program yields a specific value of time for any coin entry made after the “Amount To Start” has been
inserted.