ADC Gas Electric Steam WDA-540 - Manual (Page 38)

36
E. PROGRAM LOCATION 02 (PL02)
Percent dry from 90 to 100%
Dryness level Increase Dryness level decrease
Summary: The percentage of dryness is programmable from a minimum of 90% to a maximum of 100%.
or
PL02
Pdry
PL03
Perm Press
100 HI Temp
Perm Press
To exit
program
mode open
program
switch
LO Temp
Refer to Section V for instructions
on entering program locations.
Proceed to
next location
to be changed
(Wait 3-Seconds)
("Hold In" to Accelerate) ("Hold In" to Accelerate)
Location to be viewed/changed.
Display reads “PdrY” percent of dryness
and the actual numeric value programmed
(90-100%). If no change, press “Perm
Press” key, otherwise press the “HI” or
“LO” keys and then “Perm Press” key.