ADC Gas Electric Steam WDA-540 - Manual (Page 48)

46
O. PROGRAM LOCATION 12 (PL12)
Amount To Start
Location to be viewed/changed.
Press “Perm Press” key.
Display will read “AtSt,” amount to
start for 3-seconds and then time
programmed. If no change, press
“Perm Press” key, otherwise press
“HI” or “LO” keys and then “Perm
Press” key.
Summary: The amount to start is programmable from 1 to 9999.
PL12
AtSt
Perm Press
25 HI Temp
Perm Press
LO Temp
Refer to Section V for instructions
on entering program locations.
(Wait 3-Seconds)
("Hold In" to Accelerate) ("Hold In" to Accelerate)
PL13
Proceed to next location
to be changed
To exit program mode,
open program switch
Amount Decrease Amount Increase