Vaisala DM500 - Manual (Page 37)

Chapter 6 _____________________________________________________ Setting up for Operation
VAISALA _______________________________________________________________________ 35
CHAPTER 6
SETTING UP FOR OPERATION
This chapter provides you with information that is intended to help
you set up the product for operation.
Connection of the DMI500 and DMP501 Units
Unpack the instrument carefully and check that all parts are visually
undamaged.
Connect the DMP501 dewpoint sensing unit to the DMI500 user
interface unit as follows:
- Insert the male connector at the end of the DMP501 power cable
(see Figure 2 on page 16, item 1) into the female connector on the
back panel of the DMI500 unit. Tighten the sleeve nut (and
simultaneously press the connector in) until the connectors are
perfectly mated. If the sensing unit is not connected properly, lines
replace the measured values on the display.
- Connect the serial output cable, analog output data cable (back
panel of the DMI500) and relay connections (back panel of the
DMI500), when used. See the ports from page 17 Back Panels.
- Connect the DMI500's grounded power supply cable (provided) to
the grounded box.