Vaisala DM500 User Manual
Page 89
Chapter 16 _____________________________________________________ Serial Line Commands
VAISALA _______________________________________________________________________ 87
command R does not change the default operation mode set with the
command SMODE.
Example:
>r
0.000 'C 0.00 'C 0.00 hPa 0.00
slpm
0.000 'C 0.00 'C 0.00 hPa 0.00
slpm
S Stopping the Continuous Output
Syntax:
S<cr>
Type S to stop outputting.
ADDR Setting the Device Address
Syntax:
ADDR xx<cr>
where
xx =
0...99 (address)
The address is used in POLL mode when more than one device is
connected to one serial line.
SEND Outputting One Single Reading
Syntax:
SEND x<cr>
where
x
=
device address (0...99) in POLL state
INTV Setting the Output Interval
Syntax:
INTV xxx yyy<cr>
where
xxx
=
output interval
yyy
=
unit (s, min, h)