AMETEK 2110 Shut Height Monitor - Manual (Page 13)

Installation and Programming Manual 8
Chapter 3: Mounting and Wiring
9 Installation and Programming Manual
Chapter 3: Mounting and Wiring
5. Insert each #6-32 UNC screw into each of the monitor’s screw holes.
6. Using a 7/64" Allen wrench, secure the screws into position. This will secure
the mounting rails. Eight to 10 inch pounds of torque is required.
Resolver
The resolver is mounted and coupled to the main ram adjust drive motor, or another shaft that
rotates when the shut height is adjusted.
NOTE: Backlash and slop in the shaft will affect shut height accuracy.
LDT
The LDT is mounted on the upper pitman arm of the press with the sensing rod facing down and
next to the upper ram. The magnet assembly is mounted off the upper ram per the drawing - see
Figure 3-2. Universal mounting kit (SD0441300) will simplify mounting of LDT to the upper
pitman arm. See Figure 3-2A for a typical mounting example.
Cabling
Since the LDT rides with the upper ram, a method must be found to control the cable during a
press cycle.
AMETEK manufactures several cable termination kits which provide a junction box mounted
to the crown of the press and a coiled cord set that protects the cable and its connection to the
junction box and the LDT or resolver. (See Figure 3-2B for general mounting details).
Select the appropriate cable termination kit from the variations listed below.
1) Magnetostrictive LDT used with type V1 input on series 2110 module.
Catalog No. SD0482700L25
2) Magnetostrictive LDT used with type L1 input on series 2110 module.
Catalog No. SD0443800L25
3) Resolver used with type R1 input on series 2110 module.
Catalog No. SD0439600L25
T13692 chapter 3.indd 3/17/04, 6:31 AM 9