AMETEK 2110 Shut Height Monitor - Manual (Page 22)

Installation and Programming Manual 18
Chapter 3: Mounting and Wiring
19 Installation and Programming Manual
Chapter 3: Mounting and Wiring
Analog Output (FMOA01) Output Option A1
The Analog Output board provides two channels of analog output that can be independently
configured and scaled. Each channel can be configured for an output based upon position or
velocity. Velocity will be RPM if the sensor is a resolver or inches/mm per second if the input
sensor is an LDT. The two channels of analog output allow you to configure one analog output
to be based on position while the other channel provides a simultaneous indication of velocity.
Terminal Wire Size: No. 22-12 AWG
Figure 3-11 Pinout Diagram Analog Output
Drawing E8005099
T13692 chapter 3.indd 3/17/04, 6:31 AM 18