AMETEK 2110 Shut Height Monitor - Manual (Page 45)

Installation and Programming Manual 40
Chapter 4: Programming
41 Installation and Programming Manual
Chapter 4: Programming
2. Enter function number 403. Select the enter key.
The monitor displays “000000”
3. Enter the override code 2110. Select the enter key.
NOTE: After re-energizing either the upper or lower limit relays, the operator should move the
shut height back into its range between its upper and lower limits. If the shut height is
again moved in the wrong direction (towards the limits), the upper or lower limit relays
will again de-energize, if the relays were programmed to do so. Step 1 - 3 will have to
then be repeated.
Enter 2110
403
If your system has been purchased with the optional digital output module, the following
programming sequence will be used to configure the board for compatibility with the PLC input
card.
Output Type (200)
This function will set up the D25 connector on the digital board to output the current position
value in a Binary, BCD or Grey code format:
1. Select the function key.
The monitor displays “F-----”
2. Enter function 200. Select the enter key.
The monitor displays the function’s current value.
3. Enter either 0, 1 or 2.
0 = Binary (default)
1 = BCD
2 = Grey
Select the enter key.
200
Relay Override (403)
The Relay Override function is used to temporarily allow the press operator to readjust the
shut height once it has exceeded a programmed end limit. If the upper or lower limit relays are
wired into the power interlock system, power may be lost when the shut height goes beyond the
values programmed in the upper or lower limit functions. (For more information, see Upper End
Limit and Lower End Limit.) To override either the upper or lower limit relays, perform the
following steps:
1. Select the function key.
The monitor displays “F-----”
Enter either
0, 1 or 2
4.5: Digital Outputs
(F)
8
8
(F)
8
8
T13692 Chapter 4.indd 3/17/04, 6:50 AM 41