AMETEK 2110 Shut Height Monitor - Manual (Page 38)

Installation and Programming Manual 34
Chapter 4: Programming
35 Installation and Programming Manual
Chapter 4: Programming
3. Enter a 0 to disable this function or enter a new output type. Select the enter
key.
*If used, program Function 308. Consult the factory for settings.
This section provides descriptions and instructions for the shut height monitor setup functions.
These functions provide the means to customize the monitor’s setup for a specific installation.
Before any of these functions can be programmed, the monitor must be in program mode. To
put the monitor in program mode, see Program Mode Access in Section 4.6: Program and
Supervisory Mode Functions. The following is a list of the monitor setup functions:
n Unit of Measurement (14)
n Decimal Location (13)
n Position Hold (15)
n Auxiliary LED (16)
Unit of Measurement (14)
The Unit of Measurement function is used to select the unit of measurement for the shut height
and all position data. Measurements can be either in inches or millimeters. Enter a 0 to select
inches or enter a 1 to select millimeters. The default for this function is 0. To change the unit of
measurement, perform the following steps:
1. Select the function key.
The monitor displays “F-----”
2. Enter function number 14. Select the enter key.
The monitor displays the function’s current value.
3. Enter either 0 or 1. Select the enter key.
NOTE: If you change the unit of measurement, the decimal location shown on the monitor’s
LED display will change to the default position for the unit of measurement selected.
If you select millimeters, position data will be displayed in hundredths; selecting
inches will display data in thousandths. For more information, see Decimal Location.
Enter either 0
or 1
14
NOTE: The Unit of Measurement should be programmed prior to the scale factor on systems
using a resolver input.
4.3: Monitor Setup Functions
(F)
8
8
8
T13692 Chapter 4.indd 3/17/04, 6:50 AM 34