MagTek 99875125 - Manual (Page 106)

MagTek Device Drivers for Windows
98
Modifying a Device Driver's Settings (WNT/2000/XP)
Use the following syntax to change settings of a device:
mtcfg <port-name> <setting1> [<setting2> [<setting3>...]]
each of the settings is specified as
name=value
if value contains spaces, the whole name=value string should be enclosed in quotes (not just the
value), e.g., to specify the string “MT-85 on COM1” as the friendly name for COM5 with a baud
rate of 9600 bps, use the following syntax:
mtcfg COM5 ”FriendlyName=MT-85 on COM1” baud=9600
Following is a list of common settings that can be changed for a device. Most settings have a
default value and may be missing when the list of settings is requested for a device (e.g., by typing
“MTCFG COM5”).
Device or driver Command Line Comment
Generic RS-232 MTCFG COM5 "Generic Serial (RS-
232)" FriendlyName=MT-80
UsePort=COM1 baud=4800 parity=0
datasize=7 Be sure to specify the proper
communication parameters for the
selected device.
Generic KB MTCFG COM6 "Generic Wedge
(Keyboard)"
FriendlyName=MagReader "UsePort" is not required for
keyboard devices.
IntelliPIN RS-232 MTCFG COM7 "IntelliPIN MICR
Aux" FriendlyName=IntelliPIN
"UsePort=AUX port on MICR+" The MICR+ driver must be
installed before this driver.
IntelliPIN RS-232 MTCFG COM8 "IntelliPIN RS-232"
FriendlyName=PINPad
UsePort=COM2 Communication parameters may
be required.
IntelliPIN KB MTCFG COM9 "IntelliPIN Wedge"
"FriendlyName=IntelliPIN KB" Quotes are used for Friendly
Name to allow the space.
Mag-Wedge MTCFG COM10 "Mag-Wedge"
"FriendlyName=Wedge Reader"
MICR+ MTCFG COM11 "MICR+"
FriendlyName=MICR+ UsePort=COM1 Communication parameters may
be required.
Mini MICR RS-232 MTCFG COM12 "Mini MICR RS-232"
FriendlyName=MICRS UsePort=COM1 Communication parameters may
be required.
Mini MICR KB MTCFG COM13 "Mini MICR Wedge"
FriendlyName=MICRW
MiniWedge MTCFG COM14 "MiniWedge"
FriendlyName=MSR
MT-85 MTCFG COM15 "MT-85"
"FriendlyName=MSR Encoder"
UsePort=COM2 Communication parameters may
be required.
MT-95 MTCFG COM16 "MT-95"
FriendlyName=MT-95 UsePort=COM1
baud=9600 parity=-1 datasize=8 Communication parameters may
not be required.
Port Powered Insert
Reader MTCFG COM17 "Port-powered
insert reader"
FriendlyName=PPInsert
UsePort=COM1 No communication parameters
are required.
Port Powered Swipe
Reader MTCFG COM18 "Port-powered swipe
reader" FriendlyName=PPSwipe
UsePort=COM2 No communication parameters
are required.