MagTek 99875125 User Manual
Page 22
MagTek Device Driver for Windows
Property Access
Description
msg1 - msg4
R/W
Messages to show on LCD screen with various commands.
msg1
– used by the
read
and
display
commands
msg2
– used by the
display
and
read Card_w_pin
commands
msg3
– used by the
read Card_w_pin
command
msg4
– used by the
key_press
and
key_string
operations
To specify leading spaces, use
\x20
. See the
display
command
for more information. (IntelliPIN)
offline_enc
R/W
Set to
1
to enable encode capability in standalone mode with
keyboard;
0
prevents standalone encoding (MT-95).
oper_tout
R/W Operational
timeout
in
seconds (15-255). (IntelliPIN)
pin_blk_fmt
R/W
PIN block format (IntelliPIN):
ansi
(ANSI 9.8) or
ibm
(IBM 3624)
pinfilldig
R/W
PIN fill digit (0..9, A..F) when
pin_blk_fmt
is
ibm
(IntelliPIN)
port_name
R
Indicates the virtual port number (e.g., COM6) derived from the
friendly port name.
pwroffdelay
R/W
Power off time delay in minutes (5-255). (IntelliPIN)
s_down_tout
R/W
Shutdown timeout in hours (1-31). Set to
0
to disable. (IntelliPIN)
track1ss
track2ss
track2ss
R
R
R
Indicates Start Sentinel on Track 1 as received from the device.
Indicates Start Sentinel on Track 2 as received from the device.
Indicates Start Sentinel on Track 3 as received from the device.
trivpinchk
R/W
Set to
1
for trivial PIN checki.e., don’t allow 1234. (IntelliPIN)
trk_enable
R/W
Enable reading and writing of individual tracks. The value of this
property is a string of three characters, with
0
representing
disabled tracks and
1
representing enabled tracks, e.g.,
110
enables
tracks 1 and 2 and disables track 3.
trk1data
R
Data from track 1 excluding start sentinel and end sentinel.
trk2data
R
Data from track 2 excluding start sentinel and end sentinel.
trk3data
R
Data from track 3 excluding start sentinel and end sentinel.
visa_mac1
visa_mac2
visa_mac3
R
Message authentication codes returned by device after PIN is
collected (DUKPT mode only). (IntelliPIN)
wr_coer
R/W
Encode Coercivity Mode (MT-95). Specifies the energy level used
to encode the magnetic stripe:
0
= automatic selection
1
= LoCo only mode
2
= HiCo only mode
wr_secure
R/W
0
indicates the card can be removed between a read and write
operation. Set this to
1
to turn on secure online encode mode (MT-
95).
xact_type
R/W
Transaction type –
d
= debit,
c
= credit (IntelliPIN).
Properties like
account_no
and those properties created by the data parsing templates (see
Section 4) that are affected by a card transaction will be modified only when a card is read
without errors.
14