MagTek 99875125 - Manual (Page 87)

Appendix A. Installation and Setup
Installing Generic Driver:
The Generic driver supports RS-232 device and wedge devices. Set “Generic” to 1 under the “INSTALL”
section. By default Generic is set to 0. If you have selected to install the generic driver then change the
device settings under the “Generic” section.
If you want the generic driver for an RS-232 device then change the value of PortName, UsePort, baud,
datasize, stopbits, and parity under the “Generic” section.
Example:
[Generic]
DEVICE= Generic
FriendlyName= Generic
PortName=COM8:
UsePort=COM1:
baud=9600
datasize=7
stopbits=1
parity=EVEN
If you want the generic driver for an wedge device then change PortName, UsePort. Set the UsePort to
“KB:”
Example:
[Generic]
DEVICE= Generic
FriendlyName= Generic
PortName=COM8:
UsePort=KB:
79