MagTek 99875125 - Manual (Page 93)

Appendix A. Installation and Setup
85
Installing MiniWedge:
Set “MiniWedge” to 1 under the “INSTALL” section. . If you have selected to install the MiniWedge
driver then change the device settings under the “MiniWedge ” section.
Only PortName needs to be changed. The UsePort is already set to “KB:”.
Example:
[MiniWedge]
DEVICE=MiniWedge
FriendlyName=MiniWedge
PortName=COM5:
UsePort=KB:
Installing USB HID Swipe Reader:
Set “PPSR” to 1 under the “INSTALL” section. If you have selected to install the USB HID Swipe Reader
driver then change the device settings under the “PPSR ” section.
Change the value of PortName and UsePort.
Example:
[PPSR]
DEVICE= "Port-powered swipe reader"
FriendlyName="Port-powered swipe reader"
PortName=COM8:
UsePort=USB: