MagTek 99875125 - Manual (Page 88)

MagTek Device Drivers for Windows
80
Installing IntelliPIN:
Set :IntelliPIN” to 1 under the “INSTALL” section. If you have selected to install the IntelliPIN driver
then change the device settings under the “IntelliPIN” section.
If the IntelliPIN is a RS-232 device then change the value of PortName, UsePort, baud, datasize, stopbits,
and parity.
Example:
[IntelliPIN]
DEVICE=IntelliPIN
FriendlyName=IntelliPIN
PortName=COM8:
UsePort=COM1:
baud=9600
datasize=7
stopbits=1
parity=EVEN
If the IntelliPIN is a USB device then change the value of PortName, UsePort. Set the UsePort to “USB:”
Example:
[IntelliPIN]
DEVICE=IntelliPIN
FriendlyName=IntelliPIN
PortName=COM8:
UsePort=USB:
If the IntelliPIN is a Wedge device then change the value of PortName, UsePort. Set the UsePort to “KB:”
Example:
[IntelliPIN]
DEVICE=IntelliPIN
FriendlyName=IntelliPIN
PortName=COM8:
UsePort=KB: