MagTek 99875125 - Manual (Page 85)

Appendix A. Installation and Setup
This will bring up the Configurator showing all of the installed devices. You can make changes to any of
the parameters as required. For example, if you need to change the Virtual Port number, use the pull down
to modify the setting.
If you need to change one of the communication settings on a serial device, click the Configure… button.
Now you can change any of the settings as required. Click OK when all settings are correct. Then click
Finish in the main dialog box. The settings will be modified in the driver. You do not have to reboot after
making these changes.
77