MagTek 99875125 - Manual (Page 116)

MagTek Device Drivers for Windows
108
MINIWEDGE MSR
File Name MINIWEDG
Friendly Name(s) MiniWedge
Remarks When operating in the Windows Driver mode, the MiniWedge transmits data as
ASCII characters instead of scan codes in order to reduce the transmission time. (A
full 3-track card can be transmitted in about 0.5 second whereas in the non-driver
mode it would take almost 4 seconds.) If this creates problems in certain hardware
implementations, the skip_ascii and dev_char_delay parameters in the registry
and/or INF file can be adjusted. The default setting for dev_char_delay is "01"; if
this seems to be too fast, try setting this to "06". Additionally, the skip_ascii value
can be set to true ("01") to transmit scan codes.
Commands Supported
/cancel cmd X /load_key n key /reset X
/display [x] /rawrecv X /set prop val X
/echo string X /rawsend x X /ver X
/event n data /rawxact x X /write data
/get prop X /read [[x] y] X
Properties Supported
Property Yes Default Property Yes Default Property Yes Default
account_no chk_mod10 msg3
amount chk_number msg4
applied_fmt X chk_routing offline_enc
c_card_stat chk_status oper_tout
c_cardwpin chk_transit pin_blk_fmt
c_check 0 cmd_pending pinfilldig
c_events dblpinentry port_name X
c_keypress dev_status X pwroffdelay
c_keystring dev_version X s_down_tout
c_magnetic X 1 enable_cmc7 track1ss X
c_mechanics 0 enc_key track2ss X
c_pin enc_key_sn track3ss X
c_smart 0 enc_mode trivpinchk
c_tracks X * entry_echo trk_enable X *
c_write 0 entry_len trk1data X
c_wr_secure entry_tout trk2data X
capitalize X 1 events_on trk3data X
card_stat invalcmdrsp X 0 visa_mac1
chk_account key_parity visa_mac2
chk_amount lasterr X visa_mac3
chk_bankid max_pin_len wr_coer
chk_data msg1 wr_secure
chk_format msg2 xact_type
* = Depends on setting in the device.