Campbell Scientific UT10 10 foot Tower w/ Grounding Kit and Hinged Base - Manual (Page 16)

UT10 Weather Station
3 The State Climatologist, (1985) Publication of the American Association of
State Climatologists: Height and Exposure Standards for Sensors on
Automated Weather Stations, v. 9, No. 4 October, 1985.
4 EPA, (1989). Quality Assurance Handbook for Air Pollution Measurement
Systems, EPA Office of Research and Development, Research Triangle Park,
North Carolina 27711.
5. Overview
The UT10 tower is a versatile mount for sensors, antennas, solar panels,
environmental enclosures, radiation shields, and mounting crossarms. Its 3 m
(10 ft) height allows for wind measurements at that height.
The tower consists of 2.5 cm (1 in.) OD corrosion-resistant aluminum tubing.
In cross-section, it is 25.7 cm (10.1 in.) on a side (center of tubing to center of
tubing). It includes an adjustable mast, a hinged base, anchor bolts, lightning
rod, grounding rod, and cable tie kit.
Enclosures purchased for use with this tower must be ordered with the
“-TM” option. This will provide the necessary bracketing to mount the
enclosure to the tower.
FIGURE 5-1. UT10 Tower
6