Campbell Scientific UT10 10 foot Tower w/ Grounding Kit and Hinged Base - Manual (Page 56)

UT10 Weather Station
FIGURE 8-29. 257 Soil Moisture Sensor
8.5.16 CS210 Enclosure Humidity Sensor
Mount the CS210 inside the environmental enclosure or onto a datalogger
using the mounting block and the wire tie included with the sensor (FIGURE
8-30).
The black outer jacket of the cable is Santoprene ® rubber. This
compound was chosen for its resistance to temperature extremes,
moisture, and UV degradation. However, this jacket will support
combustion in air. It is rated as slow burning when tested
according to U.L. 94 H.B. and will pass FMVSS302. Local fire
codes may preclude its use inside buildings.
FIGURE 8-30. CS210 Installed on a CR1000
NOTE
46