2 tower installation, Tower installation, 4. install the ut10 mast – Campbell Scientific UT10 10 foot Tower w/ Grounding Kit and Hinged Base User Manual
Page 20
Advertising
UT10 Weather Station
6. Remove the top nuts, washers, and J-bolt template pieces. Leave the two
bottom nuts and one flat washer on each J-bolt. Remove the template
frame and the concrete form.
7.1.2 Tower Installation
1. Install the mast as shown in FIGURE 7-4. Attach the 3/4 inch x 10 inch
nipple to the mast using the bell reducer. Loosen the two bolts at the top
of the tower and insert the mast. For a 3 m mounting height, rest the bell
reducer against the top of the tower. Tighten the two bolts to secure the
mast.
FIGURE 7-4. Install the UT10 mast.
2. Remove the three 5/16 inch bolts, nuts, and fender washers from the UT10
mounting brace (FIGURE 7-5).
3. Pivot the three mounting feet to the vertical position.
10
Advertising