Campbell Scientific UT10 10 foot Tower w/ Grounding Kit and Hinged Base - Manual (Page 45)

UT10 Weather Station
8.5.5 107/108 Temperature Probe
Mount the 107 temperature probe inside the 41303-5A 6-plate radiation shield
as shown in FIGURE 8-17.
1. Loosen the two mounting clamp screws on the base of the radiation shield.
Insert the 107 probe through the mounting clamp until the white heat
shrink is even with the bottom of the clamp.
2. Tighten the two screws evenly until the clamp is snug against the sensor
lead.
FIGURE 8-17. 107 Temperature Probe
Mounting Clamp
107
35